UASB-FEO-氨吹脱-CASS工艺在垃圾渗滤液处理中的应用

针对垃圾渗滤液可生化性差、氨氮含量高等特点和国内处理工艺现状,采用UASB-FEO-氨吹脱-CASS工艺处理合肥市龙泉山城市垃圾填埋场垃圾渗滤液。介绍了工艺的重要构筑物及其设计参数。运行实践表明,整套装置运行平稳,出水水质满足设计要求。根据出水水质对该工艺进行技术分析以及运行结果的讨论,并与新发布的技术规范及排放标准进行对比分析。     

垃圾填埋场甲烷氧化菌及甲烷通量的研究

采用静态箱法、滚管计数法和气相色谱法,对6个不同封场时间填埋区的甲烷通量、覆土层甲烷氧化菌数量和甲烷氧化速率的变化趋势进行了测定,并分析了它们与封场时间、植被覆盖率等因素之间的相关性。结果发现6个填埋区甲烷通量的变化范围在-0.34～5.31 mg/(m2.h)之间;覆土层甲烷氧化菌的数量范围为3.10×107～20.77×107 cfu/g干土,甲烷氧化速率在1.65×10-8～4.34×10-8mol/(h.g)之间。覆土层甲烷氧化菌的数量与甲烷氧化速率呈正相关,但前者并不是后者的决定性因素;甲烷通量高时可刺激甲烷氧化菌数量及氧化速率的提高,且三者均与封场时间呈显著负相关,与植被覆盖率呈负相关;当含水率大于15%时,随着覆土层含水率的增加,甲烷氧化速率呈下降趋势;覆土pH、有机质和铵态氮与甲烷氧化速率等无明显相关性。提高覆土层的甲烷氧化速率可有效减少垃圾填埋场的甲烷排放。     

Self-inhibition can limit biologically enhanced TCE dissolution from a TCE DNAPL

Biodegradation of trichloroethene (TCE) near a Dense Non Aqueous Phase Liquid (DNAPL) can enhance the dissolution rate of the DNAPL by increasing the concentration gradient at the DNAPL-water interface. Two-dimensional flow-through sand boxes containing a TCE DNAPL and inoculated with a TCE dechlorinating consortium were set up to measure this bio-enhanced dissolution under anaerobic conditions. The total mass of TCE and daughter products in the effluent of the biotic boxes was 3-6 fold larger than in the effluent of the abiotic box. However, the mass of daughter products only accounted for 19-55% of the total mass of chlorinated compounds in the effluent, suggesting that bio-enhanced dissolution factors were maximally 1.3-2.2. The enhanced dissolution most likely primarily resulted from variable DNAPL distribution rather than biodegradation. Specific dechlorination rates previously determined in a stirred liquid medium were used in a reactive transport model to identify the rate limiting factors. The model adequately simulated the overall TCE degradation when predicted resident microbial numbers approached observed values and indicated an enhancement factor for TCE dissolution of 1.01. The model shows that dechlorination of TCE in the 2D box was limited due to the short residence time and the self-inhibition of the TCE degradation. A parameter sensitivity analysis predicts that the bio-enhanced dissolution factor for this TCE source zone can only exceed a value of 2 if the TCE self-inhibition is drastically reduced (when a TCE tolerant dehalogenating community is present) or if the DNAPL is located in a low-permeable layer with a small Darcy velocity.     

微波诱导AC/Cu、AC/Fe催化非均相Fenton 反应催化降解垃圾渗滤液

采用活性炭载体负载Cu、Fe为催化剂,在微波诱导作用下,对垃圾渗滤液污染物进行降解。实验结果表明,活性炭负载金属前经适当浓度硝酸浸泡处理后,催化剂对COD去除率提高可超过15%,过高硝酸盐浓度对COD去除有不利影响;催化剂对COD去除率随Cu、Fe金属负载量增加呈先增加后降低的趋势,催化剂对Cu、Fe的最佳负载量分别为质量百分比2.11%和1.12%。对于AC-Cu体系,在初始pH=3,H2O2投加量为4.98×103mg/L,催化剂用量为5.0×103mg/L,420 W功率下微波辐射10 min时,垃圾渗滤液COD去除率可达到84.13%;对于AC-Fe体系,当H2O2投加量为0.33×103mg/L,催化剂AC-Fe用量为2.0×104mg/L,420 W功率下微波作用10 min时,垃圾渗滤液COD去除率为60.16%。分析2种催化剂对COD去除差异的原因,可能是催化剂AC-Cu表面单分子分布的阈值比AC-Fe高。降解液的pH值对AC-Cu体系、AC-Fe体系COD去除影响存在拐点,最高COD去除率点对应的降解液pH值为3。微波辐射功率较低时,体系COD去除率随辐射功率增加而增加;辐射功率较高时,高温下垃圾渗滤液中有机硫化物分解成小分子硫化物,对催化剂活性存在一定抑制作用。     

Chemical and spectroscopic characterization of organic matter during the anaerobic digestion and successive composting of pig slurry

In this work, anaerobic digestion of pig slurry and successive composting of the digestate after centrifugation were studied by means of chemical analysis, FTIR and fluorescence spectroscopy as excitation–emission matrix (EEM). Chemical analysis highlighted the organic matter transformation occurring during the processes. A decrease of volatile solids and total organic carbon were observed in the digestate with respect to the fresh pig slurry as a consequence of the consumption of sugars, proteins, amino acids and fatty acids used by microorganisms as a C source. Water Extractable Organic Matter (WEOM) was obtained for all samples and fractionated into a hydrophilic and a hydrophobic fraction. The highest WEOM value was found in the pig slurry indicating a high content of labile organic C. The digestate centrifuged and the digestate composted showed lower hydrophilic and higher hydrophobic contents because of the decrease of labile C. Total phenolic content was lower in the digestate with respect to fresh pig slurry sample (36.7%) as a consequence of phenolic compounds degradation. The strong decrease of total reducing sugars in the digestate (76.6%) as compared to pig slurry confirmed that anaerobic process proceed mainly through consumption of sugars which represent a readily available energy source for microbial activity. FTIR spectra of pig slurry showed bands indicative of proteins and carbohydrates. A drop of aliphatic structures and a decrease of polysaccharides was observed after the anaerobic process along with the increase of the peak in the aromatic region. The composted substrate showed an increase of aromatic and a relative decrease of polysaccharides. EEM spectra provided tryptophan:fulvic-like fluorescence ratios which increased from fresh substrate to digestate because of the OM decompostion. Composted substrate presented the lowest ratio due to the humification process.     

垃圾渗滤液中典型内分泌干扰物质(EDCs)细胞毒性分析

垃圾渗滤液的人类健康风险评估日益受到人们重视,也成为研究热点。本文采用一种新型高级氧化技术UV-Fenton处理渗滤液,并用人体乳腺癌细胞(MCF-7)评估处理过程中渗滤液原液以及渗滤液中典型内分泌干扰物质(EDCs)的细胞毒性,对垃圾渗滤液中EDCs的细胞毒性和变化规律进行了研究。结果表明渗滤液中的邻苯二甲酸二丁酯(DBP)、双酚A(BPA)、壬基酚(NP)是产生细胞毒性的主要物质,其毒性大小为DBPBPANP。在同样的氧化降解过程中显示出不同毒性变化规律,通过GC-MS分析,结果显示UV-Fenton过程中产生了大量的中间产物,这也是引起毒性变化的主要原因。实验结果也说明垃圾渗滤液细胞毒性可以通过UV-Fenton过程有效去除。     

污泥活性炭强化SBR法处理垃圾渗滤液的实验研究

为了进一步处理垃圾渗滤液，试验采用污泥活性炭强化序批式间歇反应器（SBR）法进行处理，通过对比普通SBR法试验，得出投加污泥活性炭强化SBR法处理垃圾渗滤液的效果要远远高于普通SBR法。当污泥活性炭的投加量为1.2 g/L，容积负荷为0.5～1.5 kg BOD₅/(m³·d)时，进水1 h，曝气10 h，沉淀1.5 h，闲置1.5 h，处理效果最好，COD的去除率达到了85%，NH³-N的去除率达到了90%。     

生活垃圾加载介质层填埋法对初期渗滤液污染抑制效果研究

以传统卫生填埋柱R2为对照,通过往生物反应器填埋柱R1内加载可渗透反应介质层1和2进行模拟试验,主要探讨了填埋柱R1垃圾渗滤液COD、总氮、氨氮及总磷的变化趋势,探索一种新型的加载介质层垃圾填埋处理方法。试验结果表明，填埋20周后, R1柱COD浓度基本维持在40 000～45 000 mg/L间,约为R2柱的20%～30%;第24周,R1柱总氮和氨氮分别为206.5 mg/L和167.3 mg/L,在16～24周内,R1总氮和氨氮分别约为R2的14.5%～17.5%和36.2%～43.6%;18周时,R1柱总磷达最大值1.704 mg/L,至第24周降为0.673 mg/L, 整个实验过程R1柱总磷约为R2的0.15%～0.56%。     

城市生活垃圾降解率分析研究

针对城市生活垃圾降解率研究不足的现状,结合室内物理模拟实验,对垃圾温度和垃圾降解率的变化规律进行分析研究。研究结果表明,填埋初期垃圾填埋体温度升高较快,服从三次曲线变化规律;温度对垃圾降解率有重要的影响,单一温度下垃圾降解率随时间变化近似符合微生物生长曲线;不同温度下,温度高,垃圾降解率快,试验证明41.00、45.00℃垃圾降解率最快,垃圾降解率相差不大,可以认为温度高于41.00℃时垃圾降解率可以按照41.00℃时垃圾降解率计算。     

固体厌氧消化原料流变特性研究综述

厌氧消化原料的流变特性是厌氧消化工艺设计和运行的重要参数。本文从研究对象、实验操作、研究内容和结果、影响因素以及发展方向等方面对固体厌氧消化原料,特别是污泥的流变特性研究现状进行了概述。研究表明,污泥来源广泛,成分复杂,属于非牛顿流体的范畴,其流变特性受多种因素影响,其中污泥的总悬浮固体(TSS)(或混合液悬浮固体(MLSS))和温度是最主要的影响因素。大部分研究采用层流剪切实验对物料的流变特性进行表征,研究对象范围有待于扩大。尚需针对流体本构方程的改进,共消化对于原料流变特性的影响,混合液固、液相指标与流变参数的关系等方面开展研究,为利用流变参数作为工艺控制参数提供理论依据,并解决工程放大等问题。